chain tensioning

View previous topic View next topic Go down

chain tensioning

Post  james.t on Sun May 09, 2010 7:55 am

OK have adjuster my chain last week and its not quiet rite.the offside mark is in line with the exhaust so a bit hard to see. and as its 4 years old the marks aren't that clear anyway.
so have measured the thread on the adjuster bolts and 1 is 1mm small the the other can i work it out by the thread showing.
avatar
james.t

Posts : 126
Join date : 2010-05-07
Age : 49
Location : folkestone

Back to top Go down

Re: chain tensioning

Post  Admin on Mon May 10, 2010 8:19 pm

Hi James

I generally use a steel rule to measure the amount of thread showing from the adjusters.

Make sure they are of equal length then tighten the axle off, the graduation marks on the swing arm are not accuate enough and on mine are not showing on the one side.

Regards

Bob Very Happy
avatar
Admin
Admin

Posts : 137
Join date : 2010-05-05
Age : 48
Location : Birmingham

http://suzukimarauderowners.goo-board.com

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum